Convenient Features
73
Basic Guide Convenient Features
Projecting a Test Pattern from the Menu
Even without any input signals, the projector can project a test pattern. Test
patterns can be projected during installation to check how the projector is installed.
For details on projecting test patterns, see “Install settings” (P95) or “Displayed Test
Patterns” (P179).
Set Power-Saving Settings
Set power-saving settings as needed.
The following four settings are available. For details, refer to the page describing
each function.
• Lamp mode (P93)
Adjust lamp and fan power consumption in the image mode.
• Power management mode (P112)
Automatically turns off the lamp or the power after a certain period if the projector
is idle without an input signal.
• Power management duration (P113)
Specify the period after which the lamp or the projector should go off
automatically if left idle without an input signal when [Power management mode]
is set to [Lamp off] or [Standby].
• Network standby settings (P124)
Conserve energy in standby mode, as needed.
To Next Page
Loading...
Need help?
General
