Cardinal 748L User Manual

15
PWC OUTPUT STATE: UNDER PRESET WEIGHT VALUE
DIGITAL FILL CONTROL
TRUCK STORAGE
PUSH BUTTON TARE
AUTO CLEARING OF TARE
PRINTER MODEL SELECTION
ROTATE PRINT FEATURE
If 1 or more presets were entered, this prompt will appear
for each preset entered - the 1 position will indicate the
PWC number. Press ENTER to show the current setting
for the PWC output. on indicates that the PWC output is
high (the PWC relay is on) at weights under or less than
the preset weight and will switch to off (the PWC relay is off) at the preset weight
and above. oFF indicates that the PWC output is low (the PWC relay is off) at
weights under the preset weight and will switch to on (the PWC relay is on) at the
preset weight and above. Press the 0 key for off and the 1 key for on.
Press ENTER to show the current setting. Press 0 or 1 to
enter the new setting. Then press ENTER to save it or to
save the current setting.
0 = Digital Fill Control disabled
1 = Digital Fill Control enabled
Press ENTER to show the current setting. Press 0 or 9 to
enter the new setting. Press ENTER to save the new
setting or to save the current setting. This question will not
appear if Dual Ranging was selected and the decimal
point setting for the High Interval differs from the decimal
point setting for the Low Interval.
no = No Truck Storage YES= Truck Storage
Press ENTER to show the current setting. Press 0 or 1 to
enter the new setting. Then press ENTER to save it or to
save the current setting.
no = Numeric Tare YES= Push Button Tare Only
Press ENTER to show the current setting. Press 0 or 1 to
enter the new setting. Then press ENTER to save it or to
save the current setting. Clear tare on completion of the
transaction (a negative net weight after display of a
positive net weight).
no = No YES = Yes
Press ENTER to show the current printer model selection.
Press 1 through 3 to enter the new printer model to be
used. Then press ENTER to save it or to save the current
selection. The selections are as follows:
1 = Standard Printer 3 = P220 (Eltron LP-2622 and LP-2642)
2 = P200 (Elton Companion Plus) 4 = P400 (Epson U590)
If you selected 1,2, or 3, advance to
PRINTER PORT BAUD RATE.
Press ENTER to show the current SETTING. Press 0 or 1
to enter the new setting. Then press ENTER to save it or to
save the current selection.
no = normal print output YES = rotate print output 180˚
Undrl=
trSto=
PbtAr=
dFC
CLtAr=
Prt=
rtP=

Cardinal 748L Specifications

General

Brand	Cardinal
Model	748L
Category	Accessories
Language	English