19
GROSS WEIGHT PRINT LOCATION
TARE WEIGHT PRINT LOCATION
NET WEIGHT PRINT LOCATION
This display shows the current position for printing the
gross weight. If you do not wish to change it, press the
ENTER key, otherwise use the numeric keys and enter the
desired value, then press the ENTER key.
This display shows the current position for printing of the
tare weight. If you do not wish to change it, press the
ENTER key, otherwise use the numeric keys and enter the
desired value, then press the ENTER key.
This display shows the current position for printing of the
net weight. If you do not wish to change it, press the
ENTER key, otherwise use the numeric keys and enter the
desired
value, then press the ENTER key.
G=4.01
t=5.01
n=6.01
FORM LENGTH
AUTOMATIC LINE FEEDS
This display shows the number of line feeds executed after
the last printed line. If the last printed line is 5 and the form
length is 30 lines, enter 25, then press ENTER.
Data transmitted from the serial I/O port can be terminated
with a single carriage return and either no line feed or a
single line feed command. Press the ENTER key to view
the current setting. An on display means the data will be
terminated with a carriage return AND a line feed, while an
oFF display means the data will be terminated with a
single carriage return only. Press the 1 key to change the setting to on or the 0
key to change it to oFF. Once the proper setting is displayed, press the ENTER
key to save it.
AUtoLF
EoP=0
SAMPLE PRINT
REPEAT PRINTER TAB SETTINGS
This display asks if you wish to have a sample print to
verify the printed data locations. Press the ENTER key and
the display will show no. If you do not want a sample print,
press the ENTER key again. The
CALIBRATION “C”
NUMBERS will be displayed. If you do want a sample print, press the 1 key to
change the display to YES then press the ENTER key. Make certain that the
printer is on and ready to print first.
This display asks if you wish to review and change the
printer tab setting. Press the ENTER key and the display
will show no. If you are satisfied with the settings, press
the ENTER key again. If you wish to review or change any
of the settings, press 1 to change the display to YES then press the ENTER key.
The display will then return to the time print location.
Print?
AGAin?
To Next Page
Loading...
Need help?
General
