23
SETUP REVIEW
The 748P allows several operational parameters to be reviewed and changed without breaking the
calibration seal. These operational parameters are:
Power Up Zero Reset Enable/Disable
Blank Display on Motion Enable/Disable
Number of Preset Weight Comparators
Digital Fill Control Enable/Disable
Truck Storage Enable/Disable
Automatic Clearing of Tare Enable/Disable
Serial Data Port Configuration
Baud Rate
Parity
Number of Data Bits
Number of Stop Bits
Continuous Output
Printer Model Selection
CTS Enable/Disable
Print Positions (tab settings)
Time
Date
Identification
Gross Weight
Tare Weight
Net Weight
To enable the Setup Review feature, first turn the 748P off by pressing the OFF key. Press and hold
the GROSS key and press and release the ON/ZERO key. Release the GROSS key. The 748P will
respond by showing the prompt for the selection of power-up zeroing (PUO=). Using the same
procedure as described in the calibration section of this manual, make the required changes. A
chart illustrating the basic procedure is included in the manual for a quick reference but refer to the
CALIBRATION section for detailed information if in doubt.
NOTE: By pressing the PRINT key, setup review will jump to the Prt= prompt.
To Next Page
Loading...
Need help?
General
