16
SERIAL PORT BAUD RATE
SERIAL PORT PARITY
SERIAL PORT DATA BITS
SERIAL PORT STOP BITS
bAUdS=
bAUd?
CONFIGURE SERIAL PORTS
bitSS=
StoPS=
PrtYS=
Press ENTER to show the default setting (no). If you wish
to configure or review the serial data ports, press the 1 key
for YES, then press ENTER to continue. If you do not want
to change or review the configuration of the serial port
settings, press 0 for NO then press ENTER to continue. If
you bypass this section, the 748P will advance to the
PRINTER TAB SETTINGS.
Press ENTER to show the current baud rate. Use the
numeric keys to enter a new baud rate for the bi-directional
serial post. Then press ENTER to save it or to save the
current setting.
12 = 1200 Baud 48 = 4800 Baud
24 = 2400 Baud 96 = 9600 Baud 19 = 19.2K Baud
Press ENTER to show the current setting. Press 0 through
1 to enter the new parity setting for the
bi-directional serial port. Then press ENTER to save it or to
save the current setting.
0 = No Parity 1 = Odd Parity 2 = Even Parity
Press ENTER to show the current number of data bits.
Press 7 or 8 to enter the new number of data bits for the
bi-directional serial port. Then press ENTER to save it or to
save the current setting.
Press ENTER to show the current number of stop bits.
Press 1 or 2 to enter the new number of stop bits for the
bi-directional serial port. Then press ENTER to save it or to
save the current setting.
Press ENTER to show the current setting. Press 0 or 1 to
disable or enable the continuous output on the bi-
directional serial port. Then press ENTER to save the
current setting. A NO response will automatically select
weight on demand. Weight is requested by receipt of a 05
(Hex) enq.
no = No Continuous Output YES = Continuous Output
If answered YES to Continuous Output, the display will prompt:
If SB-200A or SB-400A scoreboard is attached, answer
YES. If not, answer NO. NOTE: If older style SB-200
scoreboard is attached, always answer NO.
Press ENTER to show the current baud rate. Use numeric
keys to enter the new baud rate for the printer serial port.
Then press ENTER to save it or to save the current
setting.
12 = 1200 Baud 48 = 4800 Baud
24 = 2400 Baud 96 = 9600 Baud 19 = 19.2K Baud
CONTINUOUS SERIAL OUTPUT
ContS=
5b400?
bAudP=
PRINTER PORT BAUD RATE
To Next Page
Need help?
General
