Carrier i-Vu XT Router User Manual

i-Vu® XT Router (drv_gen5) CARRIER CORPORATION ©2022
Installation and Start-up Guide 18 All rights reserved
To wire to a BACnet MS/TP network
An MS/TP network can be wired to either Port S1 or Port S2.
1 Turn on the i-Vu® XT Router's power.
2 Check the communications wiring for shorts and grounds.
3 Connect the communications wiring to the Port S1 or Port S2 screw terminals labeled Net +, Net -, and
Shield.
NOTE Use the same polarity throughout the network segment.
4 If you are using Port S1, and the controller has a Port S1 Configuration rotary switch, set it to 1.
NOTE If Port S1 is not being used for any network, set this rotary switch to 0.
5 If the i-Vu® XT Router router is at either end of a network segment, set the port's End of Net? switch to Yes.
NOTE The router’s End of Net switch applies network termination and bias. See the Open Controller Network
Wiring Guide.
6 Turn on the router's power.
7 To verify communication with the network, get a Module Status report in the i-Vu® interface for a router on
the MS/TP network.
NOTE This step requires that you have discovered and uploaded the router in the i-Vu® application.

Carrier i-Vu XT Router Specifications

General

Brand	Carrier
Model	i-Vu XT Router
Category	Network Router
Language	English