Document revision history
RTU Open v3 CARRIER CORPORATION ©2019
Installation and Start-up Guide All rights reserved
108
Important changes to this document are listed below. Minor changes such as typographical or formatting errors are not
listed.
Wireless sensor overview
To install the Wireless Adapter for
wireless sensors
Wiring devices to the RTU Open's
Rnet port
Input wiring specifications
Correction - Property is always displayed in the Startup Wizard
Sequence of operation - Linkage air
source mode determination
Clarified reason and method for generating a particular mode.
Evacuation/Shutdown changed to Evacuation.
SPT sensor overview
Simplified. Detailed descriptions are available in specified
manuals. Corrected total number of ZS sensors.
O
To install the Wireless Adapter for
wireless sensors
Wiring devices to the RTU Open's
Rnet port
Added Wireless Adapter for wireless sensors
Input wiring specifications
Added Wireless Adapter for wireless sensors
To wire the controller to the
network
Added BACnet ARC156 connection information
Wiring for communications
Changed from Wiring the RTU Open to the MS/TP network
Added BACnet ARC156 connection and Wireless Adapter for
Carrier wireless sensors. Corrected SPT information.
Sequence of Operation - Linkage
Added Linkage system safety override for Heating Mode.
Sequence of Operation - Indoor Air
CO2
This section erroneously left out - reinserted.
Added USB Link wiring caution.
Note that metric version is available.
Indoor Air CO2 section deleted because same as Space Air
Quality.
Correction - Service Test cannot be turned on or off from an
Equipment Touch.
Equipment touch
Corrected the external 10 kOhm, Type II thermistor number
from 33ZCT57SPT to 33ZCT55SPT
* For internal use only