3.9 Clerk Operation
There are three clerk modes as below.
▶ Clerk Modes
☞ To register clerk, refer to menu code 1850 of program mode. (See chapter 2.14.5)
Assumption
- Clerk should be registered on menu 1850. (See chapter 2.14.5)
- Clerk number should be set on menu 1856 to use “V1~ V64”
keys (See chapter 2.14.5.6) If the clerk is not assigned to V1~V64, this
clerk has to enter password after pressing V key.
- All clerks can use “V” key.
* Up to 50 transactions are available in Clerk mode
* Sales data is saved in memory.
* If you press PRINT key to complete transaction, grand total price is
printed and sales data is cleared from memory.
* If you want to see total price before completing transaction, press the
ST/TTL key. To print, press the PRINT key.
* Even though you turn off the scale before printing, sales data is not cleared.
If you want to print ticket when you log out, press V1~V64 to log on and press
the PRINT key. You can also check total price by pressing ST/TTL key after log
on.
To Next Page
Loading...
Need help?
General
