27 Operation
Securing the projector
Using a security cable lock
The projector has to be installed in a safe place to prevent theft. Otherwise, purchase a lock to
secure the projector. You can locate a security bar on the projector. See item 24 on page 15.
Utilizing the password function
Setting a password
1. Go to SYSTEM SETUP: ADVANCED > Password. Press ENTER. The Password page
appears.
2. Highlight Change Password and press ENTER.
3. The four arrow keys ( , , , ) respectively
represent 4 digits (1, 2, 3, 4). According to the
password you desire to set, press the arrow keys to
enter six digits for the password.
4. Confirm the new password by re-entering the new
password.
Once the password is set, the OSD menu returns to
the Password page.
5. To activate the Power On Lock function, press /
to highlight Power On Lock and press / to select On. Input the password again.
If you forget the password
If you enter the wrong password, the password error
message will appear, and the Input Current Password
message follows. If you absolutely do not remember the
password, you can use the password recall procedure.
See "Entering the password recall procedure" on
page 28.
If you enter an incorrect password 5 times in
succession, the projector will automatically shut down in a short time.
• The digits being input will display as asterisks on-screen. Make a note of your selected password and
keep it in a safe place in advance or right after the password is entered so that it is available to you
should you ever forget it.
• Once a password has been set and the power on lock is activated, the projector cannot be used unless
the correct password is entered every time the projector is started.
Password Error
Please try again.
To Next Page
Loading...
Need help?
General
