Cisco GRS User Manual

PurposeCommand or Action
Configures the ICMP protocol session. The example shows how to
configure the ICMP protocol for the CGN instance named cgn1.
protocol icmp
Example:
RP/0/RP0/CPU0:router(config-cgn-nat44)#
protocol icmp
RP/0/RP0/CPU0:router(config-cgn-proto)#
Step 4
Configures the timeout value as 908 for the ICMP session for the CGN
instance named cgn1.
timeoutseconds
Example:
RP/0/RP0/CPU0:router(config-cgn-proto)#
timeout 908
Step 5
Saves configuration changes.end or commit
Example:
RP/0/RP0/CPU0:router(config-cgn-proto)#
end
Step 6
•
When you issue the end command, the system prompts you to
commit changes:
Uncommitted changes found, commit them before exiting
(yes/no/cancel)?
or
RP/0/RP0/CPU0:router(config-cgn-proto)#
commit
[cancel]:
◦
Entering yes saves configuration changes to the running
configuration file, exits the configuration session, and returns
the router to EXEC mode.
◦
Entering no exits the configuration session and returns the
router to EXEC mode without committing the configuration
changes.
◦
Entering cancel leaves the router in the current configuration
session without exiting or committing the configuration
changes.
•
Use the commit command to save the configuration changes to
the running configuration file and remain within the configuration
session.
Configuring the Timeout Value for the TCP Session
Perform this task to configure the timeout value for either the active or initial sessions for TCP.
Cisco IOS XR Carrier Grade NAT Configuration Guide for the Cisco CRS Router, Release 5.2.x
OL-32659-01 33
Implementing Carrier Grade NAT on Cisco IOS XR Software
Configuring the Policy Functions for the Carrier Grade NAT

Cisco GRS Specifications

General

Brand	Cisco
Model	GRS
Category	Network Router
Language	English