7-23
Cisco Secure ACS 3.0 for Windows 2000/NT Servers User Guide
78-13751-01, Version 3.0
Chapter 7 Setting Up and Managing User Accounts
Advanced User Authentication Settings
PIX ACL using the Shared Profile Components section of the Cisco Secure ACS
HTML interface, see the “Adding a Downloadable PIX ACL” section on
page 5-3.
Note The Downloadable ACLs table does not appear if it has not been enabled. To
enable the Downloadable ACLs table, click Interface Configuration
followed by Advanced Options. Then select the User-Level Downloadable
ACLs check box.
To assign a downloadable PIX ACL to a user account, follow these steps:
Step 1 Perform Steps 1 through 3 of the “Adding a Basic User Account” section on
page 7-5.
Result: The User Setup Edit page opens. The username being added and edited
appears at the top of the page.
Step 2 Under the Downloadable ACLs section, click the Assign PIX ACL: check box.
Step 3 Select a PIX ACL from the list.
Step 4 Do one of the following:
a. If you are finished configuring the user account options, click Submit to
record the options.
b. To continue to specify the user account options, perform other procedures in
this chapter, as applicable.
Advanced User Authentication Settings
This section presents the activities you perform to configure user-level TACACS+
and RADIUS enable parameters.
This section contains the following subsections:
• TACACS+ Settings (User), page 7-24
• Advanced TACACS+ Settings (User), page 7-31
• RADIUS Attributes, page 7-36
To Next Page
Loading...
Need help?
General