Cisco Servers User Manual

G-27
Cisco Secure ACS 3.0 for Windows 2000/NT Servers User Guide
78-13751-01, Version 3.0
Appendix G ODBC Import Definitions
Action Codes
Action Codes for Modifying Network Configuration
Table G-6 on page G-28 lists the action codes for adding AAA clients, AAA
servers, and network device groups, in addition to proxy table entries.
Transactions using these codes affect the configuration displayed in the Network
178 SET_PERMIT_
DENY_
UNMATCHED_
IOS_
COMMANDS
UN|GN, V1 The default is that any Cisco IOS commands not
defined via a combination of Actions 174 and 175 will
be denied. This behavior can be changed so that issued
Cisco IOS commands that do not match any
command/command argument pairs are authorized:
GN=“Group 1"
V1=“permit”
or
UN=“fred”
V1=“deny”
The first example will permit any command not
defined by Action 174.
179 REMOVE_ALL_
IOS_
COMMANDS
UN|GN This action removes all Cisco IOS commands defined
for a particular user or group.
210 RENAME_
GROUP
GN,V1 Renames an existing group to the name supplied in
value 1.
211 RESET_GROUP GN Resets a group back to the factory default.
212 SET_VOIP GN, V1 Enables or disables Voice over IP (VoIP) support for
the group named, as follows:
• GN = name of group
• V1 = ENABLE or DISABLE
Table G-5 Action Codes for Modifying TACACS+ and RADIUS Group and User Settings (continued)
Action
Code Name Required Description

Cisco Servers Specifications

General

Brand	Cisco
Model	Servers
Category	Software
Language	English