Chapter 7 Setting Up and Managing User Accounts
Advanced User Authentication Settings
7-24
Cisco Secure ACS 3.0 for Windows 2000/NT Servers User Guide
78-13751-01, Version 3.0
TACACS+ Settings (User)
The TACACS+ Settings section permits you to enable and configure the
service/protocol parameters to be applied for the authorization of a user. This
section contains the following procedures:
• Configuring TACACS+ Settings for a User, page 7-24
• Configuring a Shell Command Authorization Set for a User, page 7-26
• Configuring a PIX Command Authorization Set for a User, page 7-29
• Configuring the Unknown Service Setting for a User, page 7-31
Configuring TACACS+ Settings for a User
You can use this procedure to configure TACACS+ settings at the user level for
the following service/protocols:
• PPP IP
• PPP IPX
• PPP Multilink
• PPP Apple Talk
• PPP VPDN
• PPP LCP
• ARAP
• Shell (exec)
• PIX Shell (pixShell)
• SLIP
You can also enable any new TACACS+ services that you may have configured.
Because having all service/protocol settings display within the User Setup section
would be cumbersome, you choose what settings to hide or display at the user
level when you perform configure the interface. For more information about
setting up new or existing TACACS+ services in the Cisco Secure ACS HTML
interface, see the “Protocol Configuration Options for TACACS+” section on
page 3-7.
To Next Page
Loading...
Need help?
General