Chapter 7 Setting Up and Managing User Accounts
Advanced User Authentication Settings
7-34
Cisco Secure ACS 3.0 for Windows 2000/NT Servers User Guide
78-13751-01, Version 3.0
c. Click Add Association.
Result: An entry appears in the table, associating the device group with a
particular privilege level.
d. Repeat Steps a through c for each device group you want to associate to this
user.
Tip To delete an entry, select the entry and then click Remove Associate.
Step 5 Do one of the following:
a. If you are finished configuring the user account options, click Submit to
record the options.
b. To continue to specify the user account options, perform other procedures in
this chapter, as applicable.
Setting TACACS+ Enable Password Options for a User
When setting the TACACS+ Enable Password Options for a user, you have three
options to chose from, as follows:
• Use CiscoSecure PAP password
• Use external database password
• Use separate password
To set the options for the TACACS+ Enable password, follow these steps:
Step 1 Perform Steps 1 through 3 of the “Adding a Basic User Account” section on
page 7-5.
Result: The User Setup Edit page opens. The username being added or edited
appears at the top of the page.
To Next Page
Loading...
Need help?
General