3-4
Cisco UCS Server Configuration Utility, Release 5.0
Chapter 3 Understanding UCS Server Configuration Utility User Interface
UCS-SCU GUI Home Page
This section describes the toolbar elements in more detail:
• Configuring a Network, page 3-4
• Performing Server Health Check, page 3-5
• Saving Logs, page 3-5
• Rebooting the Server, page 3-5
Configuring a Network
To configure a network, follow these steps:
Step 1 Click the Network Configuration button on the toolbar.
The Network Configuration dialog box appears.
Step 2 In the Network Configuration dialog box, do the following:
a. Select IP Address from DHCP server or Static IP Address. If you select Static IP Address, do the
following:
–
In the IP Address field, enter the IPv4 address.
–
In the Subnet Mask field, enter the subnet IPv4 address.
–
In the Gateway field, enter the gateway IPv4 address.
–
(Optional) In the DNS field, enter the DNS IPv4 address.
Note Go to Step b. if you want to download software and drivers from cisco.com.
b. Select Direct Connection to internet or Manual Proxy. If you select Manual Proxy, do the following:
–
In the HTTP Proxy Server URL field, enter the URL of the proxy server. The maximum limit is
45 characters.
–
In the Port field, enter the port number. The maximum limit is 5 characters. By default, it is
8080.
Save Logs
Saves logs to an USB.
Refresh Refreshes the content area, if supported.
Reboot Reboots the server.
Table 3-3 Toolbar Elements (continued)
Toolbar Icon Name Function
To Next Page
Loading...
Need help?
General
