Cisco UCS User Manual

6-6
Cisco UCS Server Configuration Utility, Release 5.0
Chapter 6 Installing Operating Systems
Other OS Install
Table 6-4 shows the default parameters that are displayed in the Default Settings area for the SUSE
Linux Enterprise Server (SLES) OS.
Step 5 Click Quick Install to complete the installation.
A progress bar is displayed that indicates the tasks being performed and the percentage of completion.
Note Be sure that logical disks are created before you install the operating system. If logical disks are not
available, the following occurs:
• The disk details are not displayed under Default Settings area
• The Quick Install and Custom Install buttons are not displayed
• The following warning message is displayed:
OS Installation cannot be done as no logical disks found in the system. Please use RAID
Configuration to create logical disks.
Custom Install
The Custom Install option allows you to customize the default settings.
Table 6-4 Default Parameters (for SLES)
Parameter Default Value
Time Zone America/New_York
Name root
Default Password password
Network DHCP
Drivers All drivers will be installed from the SCU boot
media
Disk Details
Disk Name LSI0-Logical Vol-2
Disk Size Depends on logical disks
Partition Details
Drive Letter /
File System ext3
Size (MB) Depends on logical disks
Drive Letter swap
File System linux-swap
Size (MB) Minimum 2048

Cisco UCS Specifications

General

Brand	Cisco
Model	UCS
Category	Server
Language	English