If the rommon 1> prompt is displayed, your system has booted in ROMmon mode. For information on
the ROMmon, see the section on using the ROMmon in the Cisco VG350, Cisco VG310 and Cisco 320
Voice Gateway Software Administration and Configuration Guide at Cisco.com.
Performing the Initial Configuration on the Voice Gateway
Use the following tools to perform the initial configuration on the voice gateway:
•
Using the setup Command Facility, on page 55
•
Using Cisco Configuration Professional Express, on page 58
• Using Cisco IOS CLI—Manual Configuration, on page 58
Using the setup Command Facility
Before You Begin
The setup command facility prompts you to enter the information that is needed to configure Cisco VG310
or Cisco VG320 quickly. The facility steps you through a initial configuration, including LAN and WAN
interfaces. For more general information about the 4719407618 command facility, see the chapter Configuration
Using Setup and Autoinstall in the Cisco IOS Configuration Fundamentals Configuration Guide, Release
12.4, at Configuration Fundamentals Configuration Guide, Cisco IOS Release 15.0S.
This section explains how to configure a hostname for the voice gateway, set passwords, and configure an
interface for communication with the management network.
If you make a mistake while using the setup command facility, you can exit and run the setup command
facility again. Press Ctrl-C, and enter the setup command in privileged EXEC mode (Router#).
Note
Procedure
Step 1
From the Cisco IOS CLI, enter the setup command in privileged EXEC mode:
Router> enable
Password: <password>
Router# setup
--- System Configuration Dialog ---
Continue with configuration dialog? [yes/no]:
You are now in the Setup Configuration Utility.
Step 2
To proceed using the setup command facility, enter yes.
The following message is displayed:
Continue with configuration dialog? [yes/no]:
At any point you may enter a question mark '?' for help.
Cisco VG310 and Cisco VG320 Voice Gateways Hardware Installation Guide
OL-31292-01 55
Configuring the Cisco VG310 and Cisco VG320 Voice Gateways
Performing the Initial Configuration on the Voice Gateway
To Next Page
Loading...
Need help?
General
