•
Modify the existing configuration or configure additional features by using the CLI:
Router> enable
Password: password
Router# configure terminal
Router(config)#
Using Cisco Configuration Professional Express
Use Cisco Configuration Professional Express web-based application to configure the initial router settings.
For detailed instructions, see the Cisco Configuration Professional Express User Guide at: http://
www.cisco.com/c/en/us/td/docs/net_mgmt/cisco_configuration_professional_express/v2_7/guides/userguide/
ccp_express_EndUser_Guide.html.
Using Cisco IOS CLI—Manual Configuration
Before You Begin
This section shows how to access the CLI to perform the initial configuration on Cisco VG310 or Cisco
VG320.
If the system configuration dialog message does not appear, a default configuration file was installed on the
voice gateway before it was shipped. See Using Cisco Configuration Professional Express, on page 58 to
configure the voice gateway.
Procedure
Step 1
Enter no as the response when the following system message is displayed:
Example:
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes/no]: no
Step 2
Press Return to terminate autoinstall and continue with manual configuration when the following message
is displayed:
Would you like to terminate autoinstall? [yes] Return
Cisco VG310 and Cisco VG320 Voice Gateways Hardware Installation Guide
58 OL-31292-01
Configuring the Cisco VG310 and Cisco VG320 Voice Gateways
Using Cisco Configuration Professional Express
To Next Page
Loading...
Need help?
General
