Cisco WS-SUP720-3B - Supervisor Engine 720 User Manual

2-10
Cisco 7600 Series Router Supervisor Engine and Route Switch Processor Guide
OL-10100-11
Chapter 2 Route Switch Processors and Supervisor Engines
RSP720 with 10GE Uplink Ports
Supported Chassis, Line Cards, and Modules
The RSP720 supports the following Cisco 7600 chassis, line cards and modules:
• Supported on all Cisco 7600 routers (including enhanced chassis) except the Cisco 7603 and the
Cisco OSR-7609
• SPA interface processors (SIPs) and their shared port adapters (SPAs): 7600-SIP-600,
7600-SIP-400, and 7600-SIP-200
• Enhanced FlexWAN module (WS-X6582-2PA)
• Ethernet services modules: 2-port 10 GE line card (7600-ESM-2X10GE) and 20-port 1 GE line card
(7600-ESM-20X1GE)
• Distributed Forwarding Cards: DFC3C, DFC3CXL, DFC3B, DFC3BXL
• LAN cards (which require CFC or DFC):
– WS-X67xx
– WS-X65xx
– WS-X64xx
– WS-X63xx
– WS-X61xx
Unsupported Hardware and Features
The following hardware and features are not supported by the RSP720:
• Unsupported chassis: Cisco 7603, Cisco OSR-7609.
• Unsupported modules: Services modules, Optical Service Modules (OSMs), FlexWAN module.
RSP720 with 10GE Uplink Ports
Cisco IOS Release 12.2SRC introduces a new RSP720 with 10 Gigabit Ethernet (GE) uplink ports
(RSP720-10GE). The Cisco 7600 RSP720-10GE consists of a full-size board and two integrated
daughter cards: an MSFC4 and a PFC. The RSP720-10GE has an integrated switch fabric that
interconnects all of the line cards in the router with point-to-point 20-Gbps full-duplex serial channels.
Two versions of the RSP720-10GE module are available:
• RSP720-3C-10GE
• RSP720-3CXL-10GE
Because of physical differences between the RSP720 and RSP720-10GE (such as the CPU memory map
and ASIC operation), there are several configuration guidelines and restrictions you should be aware of.
See the “RSP720-10GE Usage Guidelines and Limitations” section on page 2-13 for details.
Following are the total power requirements for the RSP720-10GE:
• RSP720-3C-10GE = 355 watts (total power)
• RSP720-3CXL-10GE = 378 watts (total power)
Figure 2-2 shows the RSP720-3C-10GE front panel. The RSP720-3CXL-10GE front panel is similar.
See Table 2-8 and Table 2-9 for information about the front-panel controls and LEDs.

Cisco WS-SUP720-3B - Supervisor Engine 720 Specifications

General

Brand	Cisco
Model	WS-SUP720-3B - Supervisor Engine 720
Category	Network Router
Language	English