vii
Cisco 7600 Series Router Supervisor Engine and Route Switch Processor Guide
OL-10100-11
Preface
This guide describes the route switch processors and supervisor engines supported by Cisco 7600 series
routers. It also provides technical specifications for these modules and describes cable and connector
specifications.
Caution Only trained and qualified service personnel (as defined in IEC 60950 and AS/NZS3260) should install,
replace, or service the equipment described in this document.
Contents
This preface contains the following sections:
• Document History, page vii
• Document Organization, page viii
• Document Conventions, page ix
• Related Documentation, page x
• Obtaining Documentation, Obtaining Support, and Security Guidelines, page x
Document History
Table 1 lists the technical changes made to this document since it was first printed.
Table 1 Document History
Revision Date Change Summary
OL-10100-11 March 2012 Added Supervisor Engine 2T information.
OL-10100-10 November 2010 Added scenrio information when the system LED on the
supervisor turns to orange from green in , page 4.
OL-10100-09 October 2010 Added troubleshooting information in Chapter 4,
“Troubleshooting Route Switch Processors and Supervisor
Engines”.
OL-10100-08 April 2010 Updated information about the line card firmware bundled with
the IOS image.
To Next Page
Loading...
Need help?
General
