3-14
Cisco 7600 Series Router Supervisor Engine and Route Switch Processor Guide
OL-10100-11
Chapter 3 Installing and Configuring Route Switch Processors and Supervisor Engines
Power Management and Environmental Monitoring
Removing a Flash Memory Card
Caution Do not remove a flash memory card while its LED light is on or the file may become corrupted.
To remove a flash memory card, follow these steps:
Step 1 Make sure that the Disk LED is off (no operations are in progress).
Step 2 Press the ejector button to disconnect the memory card from the connector at the back of the slot.
Step 3 Remove the memory card from the slot and place it in an antistatic bag.
Power Management and Environmental Monitoring
For detailed information on power management and environmental monitoring, see the Cisco 7600
Series Router Cisco IOS Software Configuration Guide.
Determining Software Feature Support
This section describes the Feature Navigator and Software Advisor tools. You can use these tools to
determine which features are supported on the router and the minimum Cisco IOS software requirements
for the hardware installed on your router.
Note You must have an account on Cisco.com to access the Feature Navigator or Software Advisor tool.
• To determine which software features are supported by your route switch processor or supervisor
engine, use the Feature Navigator tool at the following URL:
http://tools.cisco.com/ITDIT/CFN/jsp/index.jsp
• To check the minimum Cisco IOS software requirements for the hardware installed on your router,
use the Software Advisor tool at the following URL:
http://www.cisco.com/public/support/tac/tools.shtml
This tool does not verify whether the line cards in a system are compatible, but it does provide the
minimum Cisco IOS requirements for individual line cards, modules, or options.
Upgrading DIMMs on RSP720
This section describes how to upgrade the dynamic random-access memory (DRAM) dual inline
memory modules (DIMMs) on the Route Switch Processor 720.
Before you order a DIMM, you have to decide whether you require a MINI- DIMM or SO-DIMM. Run
the show module command to know which version you required for upgrade. If the version of the
7600-MSFC4 card is 4.0 and above, then you have to order SO-DIMM. If the version is below 4.0, then
you have to order MINI-DIMM. Refer the sample output of the command below:
To Next Page
Loading...
Need help?
General
