BIOS Utilities
The Setup Utility 5 - 3
5
Failing the POST
Errors can be detected during the POST. There are two categories, “fatal” and “non-
fatal”.
Fatal Errors
These stop the boot process and usually indicate there is something seriously wrong
with your system. Take the computer to your service representative or authorized
distributor/supplier as soon as possible.
Non-Fatal Errors
This kind of error still allows you to boot. You will get a message identifying the
problem (make a note of this message!) and you can then press F7 (the F7 on screen
will be highlighted to illustrate that the system is processing the request) for boot
options.
Press F2 (give the system a few seconds to enter Setup; the F2 on screen will be
highlighted to illustrate that the system is processing the request) to run the Setup
program and try to correct the problem. If you still get an error message after you
change the setting, or if the “cure” seems even worse, call for help.
To Next Page
Loading...
Need help?
General
