CLIVET ELFOControl2 User Manual

Page 66
SYSTEM COMPONENT CONFIGURATION
Define the belonging area for each component available in the system.
(radiator/fan coil)
Controlled component:
• Elforoom
• Elfospace
Local control from keyboard or thermostat
Terminal of reference (master)
Belonging area:
• kitchen, living room, etc.
Type of circuit assigned:
• mixed
• non-mixed
Number of circuit:
• mixed circuit n.1 / 2 / 3
• non-mixed circuit n.1 / 2 / 3
To complete the operation, drag area “1” upwards.
To modify the name, select A.
To define all the components, drag area “2” to the left.
select
20
select
21
A
Combining the terminal of reference with the master terminal in the
configuration
1
20
2
3
1
2
1/5
3/5
2/5
GIORNO
4
5
4/5 5/5
NOTTE
Component 1 :
DAY area, thermostat YES, terminal of reference NONE
Component 2 :
DAY area, thermostat YES, terminal of reference 1
Component 3 :
DAY area, thermostat YES, terminal of reference 1
Component 4 :
NIGHT area, thermostat YES, terminal of reference NONE
Component 5:
DAY area, thermostat NO, terminal of reference 4
21
end of the configuration
DAY
NIGHT
select
22 end of the configuration
22
Select:
• mix module controlled by the thermostat
• assign the area where it is installed
• name of the thermostat
• assign the booster
Do not select "thermostat presence" if the module is not equipped with a
thermostat. The system provides temperature and humidity from the
other thermostats installed in the areas served.
Installation composition
Starts the auto-configuration of elementes of the installation.
The auto-configuration may take a few minutes.
It is also possible to enable the auto-configuration also later (parameter
50 access reserved to installer / ATC)

CLIVET ELFOControl2 Specifications

General

Brand	CLIVET
Model	ELFOControl2
Category	Controller
Language	English