Communication Guide, ©ComAp – March 2014 104
IGS-NT Communication Guide 03-2014.pdf
Note: 1. Answer message contains at most eight items of Alarm list.
2. Alarm list is not separated to more messages.
Time delay
Insert time delay before serving next part of SMS command.
Syntax: d T
d … command
T … time delay in sec (in range 1 to 600)
Example: #5:accesscode d 10
Request 10 sec delay before serving next SMS command.
Return code: d_ok … time delay was successful performed
d_over … requested time delay is out of range (1 to 600 sec)
Note: Any other SMS messages are not served during time delay!
Remote switches (IG/IS-NT only)
Set or reset RemoteControl1-8 output.
Syntax: s 1/0
s … command
1/0 … set/reset
Example: #5:accesscode p0, s1 1
Enters password p0 and sets RemoteControl1 output.
Return code: p_OK,s_OK
ExtValues (IG/IS-NT only)
Enters value to ExtValue.
Syntax: e xxx
e … command
xxx … value
Example: #5:accesscode p0, e1 50
Enters password p0 and sets ExtValue1 = 50.
Return code: p_OK,e_OK
Help (IG/IS-NT only)
Request for list of supported SMS command.
Syntax: ?
Example: #5:accesscode ?
Return code: ?=(p <user:>passwd,r comm_obj,w com_obj val,c cmd_num,d sec,a,sx y,ex
y,?)…...
..... list of supported SMS commands
Note: Return code is not separated to more message.
Answer message
Answer message start with # character followed by Gen-set name. Colon separates this
header form return codes of SMS commands. Answer message is generated during serving of
received message and is sent in case that 160 characters or end of received message are
To Next Page
Need help?
General
