ComAp InteliGen NTC User Manual

Communication Guide, ©ComAp – March 2014 105
IGS-NT Communication Guide 03-2014.pdf
achieved. Answer message is sent to the originator phone number. Tree dots at the end of
message indicate separation and next following message.
Example: #5:accesscode r8252,w8252 100,r8252
answer message
#Gen-setname: 144,ok,100
Examples of SMS commands
Here is following several examples of SMS messages addresses to controller IG/IS-NT with
address 5, named ‘Gen-set name’. Access code in this controller is set to ‘accesscode’ and
password is ‘1234’. In examples are used setpoints and values 8276 – Nomin.power, 10123 –
RPM, 8315 – Controller Mode, 8235 – binary inputs, 8296 – Gen > f.
Example 1 – reading value
S
MS:
#5:accesscode r8276
read value 8276
A
nswer:
#Gen-set name:100
Example 2 – adjusting setpoint
SMS:
#5:accesscode p 1234, r8276,w8276
110,r8276
read value 8276,
write 110,
read value 8276
Answer:
#Gen-set name:ok,100,ok,110
Password was accepted,
read value of 8276 is 100,
writing to 8276 was ok,
new value of 8276 is 110
If wrong password sent: #Gen-set
name:p_er,100, w_pass, 100
Password was not accepted,
read value of 8276 is 100
writing to 8276 was not successful
read value of 8276 is still 100
Example 3 – Gen-set control and delay time
SMS:
#5:accesscode
r8276,c1,d30,r10123
read value 8276,
invoke gen-set command START,
delay 30 sec,
read value 10123
Answer:
#Gen-set name:110,ok,d_ok,1499
read value of 8276 is 110,
Gen-set command START was
accepted,
confirm delay command,
read value of 10123 is 1499
Example 4 – adjusting special setpoint
SMS:
#5:accesscode r8315,w8315
0,r8315
read value 8315,
write 0 (index of stringlist type),
read value 8315
Answer:
#Gen-set name:MAN,ok,OFF
read value of 8315 as string,
writing was ok,
read new value of 8315 as string

ComAp InteliGen NTC Specifications

General

Brand	ComAp
Model	InteliGen NTC
Category	Controller
Language	English