68D-Link DIR-890L User Manual
Section 4 - Conguration - Router Mode
Network
This section will allow you to change the local network settings of the router and to congure
the DHCP settings. In the Settings menu on the bar on the top of the page, click Network.
Click Advanced Settings... to expand the list and see all of the options.
Network Settings
LAN IP Address: Enter the IP address of the router. The default IP address is 192.168.0.1.
If you change the IP address, once you click Save, you will need
to enter the new IP address in your browser to get back into the
conguration utility.
Subnet Mask: Enter the subnet mask of the router. The default subnet mask is
255.255.255.0.
Management
Link:
The default address to access the router’s conguration is
http://dlinkrouter.local./ Here, you can replace dlinkrouter with a
name of your choice.
Local Domain
Name:
Enter the domain name (optional).
Enable DNS Relay: Disable to transfer the DNS server information from your ISP to your
computers. If enabled, your computers will use the router for a DNS
server.
DHCP Server
Advanced Settings
Status:
Enabled
DHCP IP Address Range: 192.168.0. 100 to 192.168.0. 199
DHCP Lease Time:
10080 minutes
Always Broadcast:
Enabled
(compatibility for some DHCP Clients)
WAN Port Speed: Auto
⌵
UPnP:
Enabled
IPv4 Multicast Streams:
Enabled
IPv6 Multicast Streams
Enabled
COPYRIGHT © 2016 D-Link
DIR-890L HW:A1 FW:1.10
Settings >> Network
SettingsHome
Network
Features Management
Use this section to congure the network settings for your device. You can enter a name for your device in
the management link eld, and use the link to access web UI in a web browser. Recommend to change the
management link if there are more than one D-Link devices within the network.
Network Settings
Advanced Settings ...
LAN IP Address: 192.168.0.1
Subnet Mask:
255.255.255.0
Management Link: http://
dlinkrouter .local/
Local Domain Name:
Enable DNS Relay:
Enabled
Save
To Next Page
Need help?
General
