D-Link Router User Manual

102D-Link DWR-961 User Manual
Section 3 - Conguration
SNMP (Simple Network Management Protocol) is a widely used network monitoring and control protocol that reports activity on each network device
to the administrator of the network. SNMP can be used to monitor trac and statistics of the DWR-961. The DWR-961 supports SNMP v1 and v2c.
SNMP
SNMP: Check this box to enable SNMP.
System
Contact/
Name/
Location:
Enter contact and reference information. This information is for
reference only and will be displayed when administering the
router over SNMP.
Public
community:
Enter the password public in this eld to allow read-only
access to network administration using SNMP. You can view the
network, but no conguration is possible with this setting.
Private
community:
Enter the password private in this eld to enable read/write
access to the network using SNMP.
Trap: Traps are short messages sent to remote controllers about SNMP
status. Check this box to enable them.
Trap Version: Specify SNMPv1 or SNMPv2c.
Trap Address: Specify the IP address to which the traps will be sent.
Click Apply to save your settings.

D-Link Router Specifications

General

Brand	D-Link
Model	Router
Category	Network Router
Language	English