D-Link Router User Manual

13D-Link DWR-961 User Manual
Section 3 - Conguration
Ethernet WAN Setup
On this page you can congure your Ethernet WAN connection. This would be used if you have an Internet connection from a DSL, Cable, or
other external source. Note that, by default, the 4G connection is used as your primary connection. If you are not sure which settings to use,
please contact your Internet Service Provider (ISP).
Internet Connection Settings
Prole Name: Displays the name of the current prole.
WAN Link
Type:
Indicates the interface used by the WAN connection. As of this
writing, only Ethernet is available.
Enable: Enable or Disable the interface.
LinkMode: Choose a link speed for the Ethernet interface. The default and
recommended setting is Auto.
Enable
Default Vlan:
If your WAN interface uses a VLAN ID, select Enable and ll out the
following two section. Otherwise, select Disable.
Default VLAN
ID:
If enabled, enter the default VLAN ID.
Default VLAN
Priority:
If enabled, enter the default VLAN priority.
Internet Settings
Select an Internet connection type for your Ethernet WAN. This information should
be provided by your ISP.
If you have chosen PPPoE, see PPPoE (Username / Password) on page 14.
If you have chosen Dynamic IP, see Dynamic IP (DHCP) on page 17.
If you have chosen Static IP, see Static IP on page 18.
If you have chosen Bridge Mode, see Bridge Mode (RFC-1483 Bridged) on page
19.

D-Link Router Specifications

General

Brand	D-Link
Model	Router
Category	Network Router
Language	English