40D-Link DWR-961 User Manual
Section 3 - Conguration
IPv6 LAN Setting
LAN IPv6 Gateway Interface Address Setting
WAN
interface:
If you wish to connect an IPv6 WAN connection to an IPv6 LAN
and have already created the IPv6 connection, select it from the
list. If you wish to add a new connection, see IPv6 WAN on page
35. If you do not need IPv6 on your LAN connection, select
Disable. Additional settings are only displayed if an IPv6 WAN
connection is selected.
Enable DHCP-
PD:
Enables IPv6 Prex Delegation (PD) over DHCPv6. This will
disable the LAN Global Address.
LAN Global
Address:
If DHCP-PD is disabled, specify a global address.
Advertise
Local Address
Prex:
If you have selected an Autocong Type below, you can enable
local prex advertising here.
LAN Local
Address:
If applicable, enter the LAN Local Address here.
LAN Link-
Local
Address:
Displays the link-local address.
LAN IPv6 Gateway Interface Address Setting
Autocong
Type:
Specify none, stateless, or stateful.