Dahua 6064 SERIES User Manual

42
In the main menu, from Setting->System->PTZ, you can see an interface is shown as in Figure 3-28.
Here you can set the following items:
 Channel: Select the current camera channel.
 PTZ type: There are two types: local/remote. Please select local mode if you are connect RS485
cable to connect to the Speed dome (PTZ). Please select remote mode if you are connecting to the
network PTZ camera.
 Protocol: Select corresponding PTZ protocol(such as PELCOD)
 Address: Default address is 1.
 Baud rate: Select corresponding baud rate. Default value is 9600.
 Data bit: Select corresponding data bits. Default value is 8.
 Stop bit: Select corresponding stop bits. Default value is 1.
 Parity: There are three options: odd/even/none. Default setup is none.
Figure 3-28
If you are connecting to network PTZ, the PTZ type shall be remote. See Figure 3-29.

Dahua 6064 SERIES Specifications

General

Brand	Dahua
Model	6064 SERIES
Category	Network Hardware
Language	English