Instruction SiE12-411
116 System Configuration
"
Oudoor Unit
"
Indoor Unit
"
Outdoor Unit
Appearance of the outdoor unit may differ from some models.
1. Air filter
2. Photocatalytic deodorizing filter or
Air purifying filter:
• These filters are attached to the inside of
the air filters.
3. Air inlet
4. Front grille
5. Grille tab
6. INTELLIGENT EYE sensor:
• It detects the movements of people and
automatically switches between normal
operation and energy saving operation.
7. Display
8. Air outlet
9. Flap (horizontal blade)
10. Louvres (vertical blades):
• The louvres are inside of the air outlet.
11. Operation lamp (green)
12. TIMER lamp (yellow)
13. HOME LEAVE lamp (red):
• Lights up when you use HOME LEAVE
Operation.
14. Indoor Unit ON/OFF switch:
• Push this switch once to start operation.
Push once again to stop it.
• The operation mode refers to the following
table.:
• This switch is useful when the remote
control is missing.
15. Room temperature sensor:
• It senses the air temperature around the
unit.
16. Signal receiver:
• It receives signals from the remote
controlremote control.
• When the unit receives a signal, you will
hear a short beep.
• Operation start ..............beep-beep
• Settings changed..........beep
• Operation stop ..............beeeeep
17. Air inlet:
(Back and side)
18. Air outlet
19. Refrigerant piping and inter-unit cable
20. Drain hose
21. Earth terminal:
It is inside of this cover.
19
20
21
18
17
Mode Temperature
setting
Air flow
rate
FTKD COOL 22°C AUTO
FTXD AUTO 25°C AUTO
To Next Page
Loading...
Need help?
General
