Printed Circuit Board Connector Wiring Diagram SiE12-411
58 Printed Circuit Board Connector Wiring Diagram
1. Printed Circuit Board Connector Wiring Diagram
1.1 Wall Mounted Type 20 / 25 / 35 Class
Connectors
Note: Other designations
1) S1 Connector for fan motor
2) S6 Connector for swing motor (Horizontal Flap)
3) S7 Connector for fan motor
4) S21 Connector for centralized control to 5 rooms
5) S26 Connector for signal receiver PCB
6) S27 Connector for control PCB
7) S32 Connector for heat exchanger thermistor
8) S35 Connector for Intelligent Eye Sensor PCB
1) V1 Varistor
2) JA Address setting jumper
JB Fan speed setting when compressor is OFF on thermostat
JC Power failure recovery function
∗ Refer to page 257 for more detail.
3) SW7 Forced operation ON/OFF switch
4) LED1 (GRN) LED for operation
5) LED2 (YLW) LED for timer
6) LED3 (RED) LED for intelligent eye
To Next Page
Loading...
Need help?
General
