Danfoss ECL Comfort 110 User Manual

VI.KT.G6.02 © Danfoss | 2016.05 | 47
Definitions
Comfort operation
Normal temperature in the system controlled by the schedule. During heating the ow
temperature in the system is higher to maintain the desired room temperature. During
cooling the ow temperature in the system is lower to maintain the desired room
temperature.
Comfort temperature
Temperature maintained in the heating / DHW circuit during comfort periods.
Desired ow temperature
Temperature calculated by the controller on basis of the outdoor temperature and
inuences from the room and / or return temperatures. This temperature is used as a
reference for the control.
Desired room temperature
Temperature which is set as the desired room temperature. The temperature can only be
controlled by the ECL Comfort controller if a room temperature sensor is installed.
If a sensor is not installed, the set desired room temperature however still inuences the
ow temperature.
In both cases the room temperature in each room is typically controlled by radiator
thermostats / valves.
Desired temperature
Temperature based on a setting or a controller calculation.
DHW circuit
The circuit for heating the domestic hot water (DHW).
Factory settings
Settings stored in the controller to simplify the setup of your controller the rst time.
Flow / DHW temperature
Temperature measured in the ow at any time.
Heating circuit
The circuit for heating the room / building.
Heat curve
A curve showing the relationship between actual outdoor temperature and required
ow temperature.

Danfoss ECL Comfort 110 Specifications

General

Brand	Danfoss
Model	ECL Comfort 110
Category	Controller
Language	English