Danfoss H1 Technical Information

H1P Auxiliary mounting, option H2 (SAE A, 9 teeth)
Option H2, ISO 3019-1, flange 82-2 (SAE A, 9 teeth)
P003 262E
Thread: M10x1.5-6H THD
Depth: 15 [0.591] min.
Recommended screw-in depth
1.5 x thread dia
4x
4x 53.2 ±0.18
[2.09 ±0.007]
2x 106.4 ±0.35
[4.189 ±0.014]
[3.252]
+0.003 -0
∅82.601
+0.076 -0
[3.489]
+0.005 -0
∅88.621
+0.13 -0
R0.8 MAX
[0.031]
294.956 ±2
[11.612 ±0.079]
279.83 ±2
[11.017 ±0.079]
[0.583]
+0.039
-0
14.801
+1
-0
Spline data
Number of teeth : 9
pitch fraction : 16/32
Pressure angle : 30°
Pitch-∅ : ∅14.288 [∅0.5625]
typ of fit : fillet root, side fit
Per : Ansi B92.1-1996 Class 6
8.101 ±0.25
[0.319 ±0.010]
O-ring seal required
Ref 82.22 [3.237] i.D.
2.62 [0.103] cross section
1.956
[0.077]
Mounting flange surface
Flange 82 - 2 per ISO 3019-1
To be paint free
61.68
[2.428]
Auxiliary pump
Shaft length
Specifications
Option
H2
Spline
9 teeth, 16/32 pitch
Maximum torque
1)
162 N•m [1430 lbf•in]
1)
For definitions of maximum and rated torque values, refer to Basic Information 11062168, section Shaft Torque
Ratings and Spline Lubrication.
C
Caution
Standard pad cover is installed only to retain coupling during shipping. Do not operate pump without an
auxiliary pump or running cover installed.
Technical Information
H1 Axial Piston Single Pumps, Size 069/078
Dimensions
11062169 • Rev 0700 • November 2015 43

Danfoss H1 Specifications

General

Brand	Danfoss
Model	H1
Category	Water Pump
Language	English