Danfoss H1 Technical Information

H1P Auxiliary mounting, option H5 (SAE B-B, 15 teeth)
Option H5, ISO 3019-1, flange 101-2 (SAE B-B, 15 teeth)
P003 261E
Thread: M12x1.75-6H THD
Depth : 20 [0.787]min.
Recommended screw-in depth
1.5 x thread dia
4x
4x 73 ±0.175
[2.874 ±0.007]
2x 146 ±0.35
[5.748 ±0.014]
Spline data
Number of teeth : 15
Pitch fraction : 16/32
Pressure angle : 30°
Pitch-∅ : ∅23.813 [∅0.938]
Typ of fit : fillet root, side fit
Per : ansi b92.1-1996 class 6
279.83 ±2
[11.017 ±0.079]
[4.002]
+0.003 -0
∅101.651
+0.076 -0
[4.245]
+0.005 -0
∅107.823
+0.13 -0
R0.8 MAX
[0.031]
O-ring seal required
Ref 101.32 [3.989] id x
2.62 [.103] cross section
295.486 ±2
[11.633 ±0.079]
1.956
[0.077]
11.4 ±0.25
[0.449 ±0.010]
[0.780]
+0.039
-0
19.8
+1
-0
Mounting flange surface
Flange 101 - 2 per ISO 3019-1
To be paint free
61.68
[2.428]
Auxiliary pump
Shaft length
Specifications
Option
H5
Spline
15 teeth, 16/32 pitch
Maximum torque
1)
693 N•m [6130 lbf•in]
1)
For definitions of maximum and rated torque values, refer to Basic Information 11062168, section Shaft Torque
Ratings and Spline Lubrication.
C
Caution
Standard pad cover is installed only to retain coupling during shipping. Do not operate pump without an
auxiliary pump or running cover installed.
Technical Information
H1 Axial Piston Single Pumps, Size 069/078
Dimensions
46 11062169 • Rev 0700 • November 2015

Danfoss H1 Specifications

General

Brand	Danfoss
Model	H1
Category	Water Pump
Language	English