H1P Auxiliary mounting, option H1 (SAE A, 11 teeth)
Option H1, ISO 3019-1, flange 82-2 (SAE A, 11 teeth)
P003 321E
Thread: M10x1.5-6H THD
Depth: 15 [0.591] min.
Recommended screw-in depth
1.5 x thread dia
4x
2x 106.4 ±0.35
[4.189 ±0.014]
4x 53.2 ±0.18
[2.09 ±0.007]
[3.252]
+0.003
0
∅82.601
+0.076
0
[3.489]
+0.005
0
∅88.621
+0.13
0
279.83 ±2
[11.017 ±0.079]
Spline data
Number of teeth : 11
Pitch fraction : 16/32
Pressure angle : 30°
Pitch-∅ : ∅17.463 [∅0. 6875]
typ of fit : fillet root, side fit
Per : Ansi B92.1-1996 Class 6
min active spline length 10.5mm
294.956 ±2
[11.612 ±0.079]
O-ring seal required
Ref 82.22 [3.237] i.D.
2.62 [0.103] cross section
R0.8 MAX
[0.031]
[0.780]
+.039
0
19.801
+1
0
1.956
[0.077]
8.1 ±0.25
[0.319 ±0.010]
61.68 MAX.
Auxiliary pump
Shaft length
Mounting flange surface
Flange 82 - 2 per ISO 3019-1
To be paint free
Specifications
Option
H1
Spline
11 teeth, 16/32 pitch
Maximum torque
1)
296 N•m [2620 lbf•in]
1)
For definitions of maximum and rated torque values, refer to Basic Information 11062168, section Shaft Torque
Ratings and Spline Lubrication.
Caution
Standard pad cover is installed only to retain coupling during shipping. Do not operate pump without an
auxiliary pump or running cover installed.
Technical Information
H1 Axial Piston Single Pumps, Size 069/078
Dimensions
44 11062169 • Rev 0700 • November 2015
To Next Page
Loading...
Need help?
General
