Danfoss VLT 2800 Design Guide

5.5 Parameter List with Factory Settings
PNU # Parameter description Factory setting 4-set-up Conv. index Data type
001 Language English No 0 5
002 Local/remote operation Remote-controlled Yes 0 5
003 Local reference 000,000.000 Yes -3 4
004 Active Setup Setup 1 No 0 5
005 Programming Setup Active Setup No 0 5
006 Setup copying No copying No 0 5
007 LCP copy No copying No 0 5
008 Display scaling 1.00 Yes -2 6
009 Large display readout Frequency [Hz] Yes 0 5
010 Small display line 1.1 Reference [%] Yes 0 5
011 Small display line 1.2 Motor current [A] Yes 0 5
012 Small display line 1.3 Power [kW] Yes 0 5
013 Local control Remote control as par. 100 Yes 0 5
014 Local stop/reset Active Yes 0 5
015 Local jog Not active Yes 0 5
016 Local reversing Not active Yes 0 5
017 Local reset of trip Active Yes 0 5
018 Data change lock Not locked Yes 0 5
019 Operating status at power up Forced stop, use saved ref. Yes 0 5
020 Lock for Hand mode Active No 0 5
024 User-defined Quick Menu Not active No 0 5
025 Quick Menu Setup 000 No 0 6
Table 5.16 Factory Settings for Parameters 001-025
4-Set-up
Yes means that the parameter can be programmed
individually in each of the 4 set-ups, i.e. one single
parameter can have 4 different data values. No means that
the data value is the same in all set-ups.
Conversion index
This number refers to a conversion factor to be used when
writing or reading via serial communication with a
frequency converter.
See chapter 4.7.4 Data Character (Byte) for further
information.
Data type
Data type shows the type and length of the telegram.
Data type Description
3 Integer 16
4 Integer 32
5 Unsigned 8
6 Unsigned 16
7 Unsigned 32
9 Text string
Table 5.17 Data Type
All about VLT 2800
Design Guide
148 Danfoss A/S © Rev. May/2014 All rights reserved. MG27E402
55

Danfoss VLT 2800 Specifications

General

Brand	Danfoss
Model	VLT 2800
Category	DC Drives
Language	English