Danfoss VLT 2800 Design Guide

1.13.9 Parameter Selection
Press [Menu] to start the Menu mode, which produces the
following readout in the display:
50.0 Hz
FREQUENCY
0 KEYB.&DISPLAY
Illustration 1.34 Menu Mode Display
Line 3 in the display shows the parameter group number
and name.
In Menu mode, the parameters are divided into groups.
Selection of parameter group is effected using the [< >]
keys.
The following parameter groups are accessible:
Group no. Parameter group
0 Operation & Display
1 Load & Motor
2 References & Limits
3 Inputs & Outputs
4 Special functions
5 Serial communication
6 Technical functions
When the required parameter group is selected, select the
parameter with the [+]/[ -] keys:
FREQUENCY
001 LANGUAGE
ENGLISH
50.0 Hz
Illustration 1.35 Select a Parameter
The third line of the display shows the parameter number
and name, while the status/value of the selected
parameter is shown in line 4.
Changing data
Regardless of whether a parameter is selected under the
Quick Menu mode or the Menu mode, the procedure for
changing data is the same. Press [Change Data] to change
the selected parameter, following which the underlining in
line 4 flashes on the display. The procedure for changing
data depends on whether the selected parameter
represents a numerical data value or a text value.
Changing a data value
If the selected parameter is a text value, change the text
value with the [+] or [-] key.
50.0 Hz
FREQUENCY
001 LANGUAGE
ENGLISH
Illustration 1.36 Change a Data Value
The bottom display line shows the value that is entered
(saved) when acknowledgment is given [OK].
Change of numeric data value
If the selected parameter is represented by a numerical
data value, select a digit with the [◄] or [►] key.
50.0 Hz
SETUP
1
FREQUENCY
130 START FREQUENCY
09.0 HZ
Illustration 1.37 Change a Numeric Data Value - I
The selected digit can then be changed infinitely variably
with the [+] or [-] key:
50.0 Hz
SETUP
1
FREQUENCY
130 START FREQUENCY
10.0 HZ
Illustration 1.38 Change a Numeric Data Value - II
The selected digit is indicated by the digit flashing. The
bottom display line shows the data value that is entered
(saved) when signing off with [OK].
Introduction to VLT 2800
Design Guide
30 Danfoss A/S © Rev. May/2014 All rights reserved. MG27E402
1
1

Danfoss VLT 2800 Specifications

General

Brand	Danfoss
Model	VLT 2800
Category	DC Drives
Language	English