Illustration 3.25 VLT 2880-2882 380-480 V
VLT 2840 PD2
NOTICE
The units are supplied with 2 bottom plates; one for
metric glands and one for conduits.
3.4 Terminals
3.4.1 Safety Clamp
Illustration 3.26 Safety Clamp
CAUTION
If the galvanic isolation (PELV) between control terminals
and high-voltage terminals is to be maintained, the
accompanying safety clamp must be fitted to VLT
2803-2815, 200-240 V, and VLT 2805-2815, 380-480 V.
Failure to fit the safety clamp could result in equipment
damage.
Installation Design Guide
MG27E402 Danfoss A/S © Rev. May/2014 All rights reserved. 47
3 3
To Next Page
Loading...
Need help?
General