Danfoss VLT AutomationDrive FC 361 Programming Guide

4.11 Parameters: 12-** Ethernet
4.11.1 12-0* IP Settings
12-00 IP Address Assignment
Option: Function:
Select the IP address assignment
method.
[0] MANUAL IP address can be set in
parameter 12-01 IP Address IP
Address.
[1] DHCP IP address is assigned via DHCP
server.
[2] BOOTP IP address is assigned via BOOTP
server.
[10] * DCP DCP is assigned via the DCP
protocol.
[20] From node ID
12-01 IP Address
Range: Function:
0* [0 -
4294967295 ]
Congure the IP address of the
option. Read-only, if
parameter 12-00 IP Address
Assignment is set to DHCP or
BOOTP. In POWERLINK, the IP
address follows the
parameter 12-60 Node ID last byte
and the rst part is xed to
192.168.100 (node ID).
12-02 Subnet Mask
Range: Function:
0* [0 -
4294967295]
Congure the IP subnet mask of the
option. Read-only, if parameter 12-00 IP
Address Assignment is set to DHCP or
BOOTP. In POWERLINK, it is xed to
255.255.255.0.
12-03 Default Gateway
Range: Function:
0* [0 -
2147483647 ]
Congure the IP default gateway of
the option. Read-only, if
parameter 12-00 IP Address
Assignment is set to DHCP or
BOOTP. In a non-routed network,
this address is set to the IP address
of the IO Device.
12-04 DHCP Server
Range: Function:
0* [0 -
2147483647 ]
Read-only. Show the IP address of
the found DHCP or BOOTP server.
12-05 Lease Expires
Range: Function:
Size
related*
[ 0 - 0 ] Read-only. Show the lease time left
for the current DHCP-assigned IP
address.
12-06 Name Servers
Range: Function:
0* [0 -
2147483647 ]
IP addresses of domain name
servers. Can be automatically
assigned when using DHCP.
12-07 Domain Name
Range: Function:
0 [0 - 48 ] Domain name of the attached
network. Can be automatically
assigned when using DHCP
network.
12-08 Host Name
Range: Function:
0* [0 - 48 ] Logical (given) name of option.
NOTICE
The display of the frequency
converter only shows the rst
19 characters, but the
remaining characters are
stored in the frequency
converter. If hardware switches
are dierent from all ON or all
OFF, the switches have priority.
12-09 Physical Address
Range: Function:
0* [0 - 17 ] Read-only. Show the physical (MAC)
address of the option.
4.11.2 12-1* Ethernet Link Parameters
Apply to the whole parameter group.
Index [0] is used for port 1, and index [1] is used for port
2.
12-10 Link Status
Read-only. Shows the link status of the Ethernet ports.
Option: Function:
[0] * No Link
[1] Link
Parameter Descriptions VLT® AutomationDrive FC 361
112 Danfoss A/S © 03/2019 All rights reserved. MG06J202
44

Danfoss VLT AutomationDrive FC 361 Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 361
Category	DC Drives
Language	English