8 Installation
Remove Shipping Items
The system is shipped with inserts that secure internal components during transport. Remove
these items before proceeding with setup.
Remove Shipping Items from the Embosser
1. Unlock and open the embosser supplies access door.
2. Remove the indent ribbon and topping foil cartridges.
3. Remove the foam “T” and block inserts used to secure the topping and transport
mechanisms during shipping. Save the inserts in case you need to repack the embosser for
transport.
4. If you plan to secure the embosser to a worktable, refer to “Secure the System (Optional)” on
page10.
Save the shipping cartons and packing materials. They are required if you need to store,
move, or return the system for service.
To Next Page
Loading...
Need help?
General
