Exit and Save Configuration
CODE 128 FAMILY
disable the family
ÌAI0]Î
Read the desired family code
Code 128
control without transmission of
check digit
ISBT 128
EAN 128
enabling ISBT 128 automatically
control without transmission of
Transmit GS Before Code
Code EAN 128 uses the ASCII <GS> character to separate a variable length code field from the
next code field. This character can also be transmitted before the code.
enable
If the <GS> character has been modified in the Character Replacement parameter, the new
character is affected by this command.
The code length selection is valid for the entire Code 128 family and is calculated on the
output string.
Read the code +
numbers for the code length where:
First 2 digits = minimum code length.
Second 2 digits = maximum code length.
The maximum code length is 99 characters.
The minimum code length must always be less than or equal to the maximum.
Examples:
= variable from 1 to 99 digits in the code.
= 10 digit code length only.
To Next Page
Loading...
Need help?
General
