Datalogic PowerScan D8330 User Manual

MESSAGE FORMATTING
193
5.17 16-KEY POWERSCAN M8300-DK
DISPLAY AND KEYPAD PARAMETERS
5.17.1 16-key Keyboard Data Format Enable/Disable
The default Data Format is configured in the scanner system, and valid for all
PowerScan models. They will be applied to the read barcode by the scanner. This is
the typical method of configuration for all M8300 models, including the M8300-DK.
Therefore, the Keyboard Data Format on the DK model does not overwrite or
substitute for the default Data Format, but is potentially additional.
On the M8300-DK the following configuration scenarios are available:
Keyboard Data Format= Disabled
• Scanner Data Header/Terminator = not null
Formatting is applied identically to a label read or data input from the
keyboard (as programmed with Scanner Data Header/Terminator on page
146). Keypad Data Header/Terminator will be ignored in this case.
Keyboard Data Format= Enabled
• Scanner Data Header/Terminator = not null
Scanner Data Header/Terminator formatting is applied only to data received
from a scanned barcode label (see page 146).
Keypad Data Header/Terminator formatting is applied only to data input from
the keypad (see page 148).
In all the above cases Scanner Code ID and Scanner Code Length are not affected
.
NOTE: This configuration item is part of the scanner configuration but is applied to
the whole system. The configuration does not overwrite the default Data Format, but
is additional.

Datalogic PowerScan D8330 Specifications

General

Brand	Datalogic
Model	PowerScan D8330
Category	Barcode Reader
Language	English