REFERENCES
5.14.2 Copy PowerScan M8300 Series
Using the slave reader and its BC-80X0 cradle, follow the initialization
procedure in chapter 4 of this manual or from the Quick Reference Guide.
With the master PowerScan
M8300 (correctly configured reader), read the
Copy Configuration barcode below. Then place it onto an BC-80X0 cradle within
10 seconds. The reader will beep indicating the configuration has been copied.
The configuration will be simultaneously sent over the RS-
BC-80X0. If this causes undesired effects disconnect the RS-
232 cable
between the PC and BC-80X0 during this process.
Copy Configuration
With the slave PowerScan M8300, read the Get Configuration barcode below.
Then place it onto the same BC-80X0 cradle used in the step above. The slave
reader's address will not be changed
Get Configuration
The configuration will be copied from the master to the slave PowerScan M8300.
The slave PowerScan M8300 signals the end of the procedure with a series of
beeps. It is now ready to be used with its own BC-80X0 cradle.
Repeat the pro
cedure above to configure other slave readers. The
BC-
80X0 can continue to configure slave readers until it receives another
command or data.
To Next Page
Loading...
Need help?
General
