6
POWERSCAN™ PD/PM96XX
CHAPTER 2
SETUP
UNPACKING
Check carefully to ensure the reader and any cables or accessories ordered are present
and undamaged. If any damage occurred during shipment, contact "
Technical Support"
on page xiv
.
SETTING UP THE POWERSCAN™ PD96XX READER
Follow the steps below to connect and get your reader up and communicating with its
host.
1. Connect the Cable to the reader and the Host (see
page 6).
2. Configure the Interface (see
page 29).
3. Configure the Reader starting
page 34 (optional, as needed).
Connect the PowerScan™ by plugging directly into the host device as shown. The power
can also be supplied through an external power supply via the Interface Cable supplied
with a power jack.
CONNECT HOST INTERFACE
Connecting the Cable
The reader kit you ordered to match your interface should provide a compatible cable
for your installation. If this is not so, contact "
Technical Support" on page xiv.
Follow the steps below to connect the cable to the reader.
1. Use a screwdriver to open the handle.
To Next Page
Loading...
Need help?
General
