QR CODE ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
217
QR Code Set Length 1
This feature specifies one of the bar code lengths for "QR Code Length Control" on page
216
. Length 1 is the minimum label length if in Variable Length Mode, or the first fixed
length if in Fixed Length Mode. Characters can be set from 0001 to 7,089 characters in
increments of 0001 (pad with zeroes).
See "
Set Length 1" on page 301 for detailed instructions on setting this feature.
QR Code Set Length 2
This feature specifies one of the bar code lengths for "QR Code Length Control" on page
216
. Length 2 is the maximum label length if in Variable Length Mode, or the second
fixed length if in Fixed Length Mode. Characters can be set from 0001 to 7,089 charac-
ters in increments of 0001 (pad with zeroes).
See "
Set Length 2" on page 302 for detailed instructions on setting this feature.
Select QR Code Length 1 Setting
$CQRL1
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in Appendix D, Keypad represent-
ing your desired character(s). End by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
0001 = Length 1 is 1 Character
Select QR Code Length 2 Setting
$CQRL2
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in Appendix D, Keypad represent-
ing your desired character(s). End by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
Length 2 i s 7,089 Characters
To Next Page
Loading...
Need help?
General
