To Next Page

To Previous Page

ENTER/EXIT PROGRAMMING MODE DISPLAY AND KEYBOARD FEATURES

224

POWERSCAN™ PD/PM96XX

DISPLAY AND KEYBOARD FEATURES

Two keyboard models are available, the 4-key model and the 16-key model. The following

section contains configuration parameters that are common and applicable to both keypad

models, unless specifically labeled as "4-key models only" or "16-key models only”.

For more items for the 16-key model, see

Additional Features for 16-key Models, starting

on page 235

Display Operating Mode

Select the operating mode of the display. Options are:

• Normal Mode: Display not cleared, no echo of the code on Display.

• Local Echo: Display cleared after decode, echo of the code on display.

• Clear display after decode: Display is cleared after decode, no echo.

Display Off Timeout

Sets the timeout for display, backlight and keyboard.

$CDIMD00

Normal Mode = Display not cleared



Local echo mode

$CDIMD01

$CDIMD02

Clear display after decode

$CDIOT00

Display Off Timeout = Disabled

Set Display Off Timeout

$CDIOT

To configure this feature, scan the ENTER/EXIT PRO-

GRAMMING MODE bar code above, then the bar code

at left followed by two digits (01-99 sec.) from the

Alphanumeric characters in Appendix D, Keypad rep-

resenting your desired character(s). End by scanning

the ENTER/EXIT bar code again.

Make a mistake? Scan the CANCEL bar code to abort

and not save the entry string. You can then start again

at the beginning.

CANCEL



08 = 8 second delay

Datalogic PowerScan PD96 Series User Manual

Questions and Answers: