ENTER/EXIT PROGRAMMING MODE 2D SYMBOLOGIES
210
POWERSCAN™ PD/PM96XX
Maxicode Set Length 2
This feature specifies one of the bar code lengths for "Maxicode Length Control" on page
209
. Length 2 is the maximum label length if in Variable Length Mode, or the second
fixed length if in Fixed Length Mode. Characters can be set from 0001 to 0145 characters
in increments of 0001 (pad with zeroes).
See "
Set Length 2" on page 302 for detailed instructions on setting this feature.
Select Maxicode Length 2 Setting
$CMXL2
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in Appendix D, Keypad represent-
ing your desired character(s). End by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
Length 2 is 0145 Characters
To Next Page
Loading...
Need help?
General
