CAUTION: On an AC switch, use the power cable as the main disconnect device. Ensure that the socket-outlet is
located and installed near the equipment and is accessible.
NOTE: Software controls the module power. You do not see module LEDs when the switch powers up in ONIE.
Storing components
If you do not install your N3200-ON Series switch and components immediately, properly store the switch and all components
using these guidelines:
● Storage location temperature must remain constant. The storage range is from -40°C to 70°C (-40° to 158°F).
● Store on a dry surface or floor, away from direct sunlight, heat, and air conditioning ducts.
● Store in a dust-free environment.
NOTE: ESD damage can occur when components are mishandled. Always wear an ESD-preventive wrist or heel ground
strap when handling the N3200-ON Series switch and accessories. After you remove the original packaging, place the
N3200-ON Series switch and components on an antistatic surface.
Site preparations 23
To Next Page
Loading...
Need help?
General