490 Understanding the Printer Menus
Fax Settings
Use the Fax Settings menu to configure the basic fax settings.
NOTE: Values marked by an asterisk (*) are the factory default menu settings.
Receive Mode
Purpose:
To select the default fax receiving mode.
Values:
Auto Rec Fax
Purpose:
Ye s Initializes the wired network data stored in NVM.
No
*
Does not initialize the wired network data stored in NVM.
Telephone Automatic fax reception is turned off. You can receive a fax by
picking up the handset of the external phone and then pressing the
remote receive code, or by setting
OnHook to On (you can hear
voice or fax tones from the remote machine) and then pressing
.
Fax
*
Automatically receives faxes.
Telephone/Fax When the printer receives an incoming fax, the external telephone
rings for the time specified in
Auto Rec Tel/Fax, and then the
printer automatically receives a fax. If an incoming call is not a fax,
the printer beeps from the internal speaker indicating that the call is a
telephone call.
Ans
Machine/Fax
The printer can share a telephone line with an answering machine. In
this mode, the printer will monitor the fax signal and pick up the line
if there are fax tones. If the phone communication in your country is
serial, this mode is not supported.
DRPD Before using the Distinctive Ring Pattern Detection (DRPD) option, a
distinctive ring service must be installed on your telephone line by the
telephone company. After the telephone company has provided a
separate number for faxing with a distinctive ring pattern, configure
the fax setup to monitor for that specific ring pattern.
Downloaded from ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
Weight and Dimensions
